mauser repair tool question

Bolt guns, gas guns and long range shooting tactics.
Ben V.
Posts: 72
Joined: Sun Sep 02, 2018 12:36 pm
Location: Citrus County

mauser repair tool question

Post by Ben V. »

I have a mauser yugo m48 that seems to have either a burr or mashed metallic piece of debris in the rear of the rear recoil lug channel of the receiver that is causing my bolt to stick after firing. i cant get in there with standard dremel bits (shafts are too short) I have looked at tooling at the big stores, and im at a loss of what to use. should i get a broaching bit? whatever i do, if i overdo it, is going to affect the accuracy of the gun, but i cant hammer the bolt open after every other shot, either.

it needs to be a 4-5" or longer hooked tool that i use to remove or more likely grind down this anomaly. any thoughts would be appreciated, cause im drawing a blank here, folks....

Posts: 25
Joined: Thu Jul 19, 2018 12:28 pm
Location: fort lauderdale

Post by mgunner »

a picture would help

Post Reply