Page 3 of 3

Re: Should I Red Locktite my buffer tube???

Posted: Fri Jun 14, 2019 7:35 pm
by Lastrites
O ring won't hold up I doubt, and even using red as long as it is just a couple of drops is fine as a fair amount of heat will break it down.

Re: Should I Red Locktite my buffer tube???

Posted: Sat Jun 22, 2019 11:01 am
by Ben V.
o ring still holding strong on the hammer drill chuck/ weeks later......

Re: Should I Red Locktite my buffer tube???

Posted: Sat Jul 06, 2019 8:32 pm
by 10MMgary
Lastrites wrote: Fri Jun 14, 2019 7:35 pm O ring won't hold up I doubt, and even using red as long as it is just a couple of drops is fine as a fair amount of heat will break it down.
I don't know but I would think it would depend on the O-ring, you would be surprised at some of the intense applications and hazardous conditions they use "O-rings" in.

Re: Should I Red Locktite my buffer tube???

Posted: Fri Jul 19, 2019 6:49 pm
by Ben V.
ok, the O ring on the hammer drill was still working, but i replaced it because it was looking sad. how long was that? i think a 1/8" oring would work in your case...

i cant believe it wont work in your specific case if you modify the application slightly...its gotta work....

Re: Should I Red Locktite my buffer tube???

Posted: Sat Jul 20, 2019 4:22 am
by Wakko
Fixed it once and for all:

Image

Re: Should I Red Locktite my buffer tube???

Posted: Sat Jul 20, 2019 3:49 pm
by better2have&notneed
Here's another option...

More pics:


Image

Re: Should I Red Locktite my buffer tube???

Posted: Sat Jul 20, 2019 7:19 pm
by SilentRecon
Wakko wrote:Fixed it once and for all:

Image
Oh my my my...
better2have&notneed wrote:Here's another option...

More pics:


Image
After he finished ultimate master smithing securing his buffer he then went on to master the glock stipple..Image

Sent from my SM-N950U using Tapatalk